Heatshrink Backshell Kit

• Spin-coupling EMC adaptor with pre-installed screened heat shrink boot
• Reliable single part construction for simple combined screen termination and environmental protection
• High levels of screening performance through integral braid
• Wide cable range for each adaptor size
• Only standard heat shrink tooling required for termination or re-work
• Solid machined adaptor construction for reliable strength and performance
• Straight, 45° and 90° standard.  Alternative angles on request
• Alternative lengths on request

Equivalent to KTKK

The new Polamco parts offer a superior design because:

• The unreliable silver epoxy joint to the adaptor is replaced by a magnaformed ring
• The thin electroplated layer is replaced by a high performance tinned copper braid
• Increased widths of adhesives used to terminate to the cable braid and jacket increase reliability and decrease craft sensitivity
• Higher performance materials including the conductive hot metal tape ensure higher electrical performance

Attachments:

TAKA Series	[A-TO FIT TYPICAL CONNECTOR: MIL-DTL-26482 SERIES II, MIL-DTL-83723 SERIES III, MIL-DTL-5015G]	[A]
TAKD Series	[D-TO FIT TYPICAL CONNECTOR: MIL-DTL-26482-SERIES I, PATT 105, PATT 603]	[D]
TAKF Series	[F-TO FIT TYPICAL CONNECTOR: MIL-DTL-38999 SERIES I]	[F]
TAKF Series	[F-TO FIT TYPICAL CONNECTOR: MIL-DTL-38999 SERIES II]	[FS]
TAKH Series	[H-TO FIT TYPICAL CONNECTOR: MIL-DTL-38999 SERIES III & IV]	[H]
TAK-NB Series	[H-TO FIT TYPICAL CONNECTOR: MIL-DTL-38999 SERIES III & IV]	[HNB]
TAKK Series	[K-TO FIT TYPICAL CONNECTOR: MIL-DTL-26482 SERIES I (TOOTHLESS VERSION)]	[K]
TAKL Series	[L-TO FIT TYPICAL CONNECTOR: MIL-DTL-5015D (TOOTHLESS VERSION)]	[L]
TAKLC Series	[LC-TO FIT TYPICAL CONNECTOR: MIL-DTL-5015 (CANNON “CA-BAYONET”)]	[LC]
TAKM Series	[M-TO FIT TYPICAL CONNECTOR: LN29729 - VG96912 - PAN 6433-2 - JN1003 ]	[M]
TAKQ Series	[Q-TO FIT TYPICAL CONNECTOR: MIL-DTL-5015D “ABB M.S.”]	[Q]
TAKR Series	[R-TO FIT TYPICAL CONNECTOR: PAT 121A]	[R]
TAKS Series	[S-TO FIT TYPICAL CONNECTOR: PATTERN 608 EXCLUDING STYLES 37T & 57T]	[S]
TAKZ Series	[Z-TO FIT TYPICAL CONNECTOR: MIL-C-28840]	[Z]